The Corne Comptroller keyboard case is made from real walnut. After laser cutting, the plates are treated with two coats of linseed oil over the course of five to six days.
Information about the Corne keyboard along with the source files from the designer can be found on the Corne Github repository. QMK key mappings and firmware can be found here.
The following components are included with the case.
| 2 | Switch Plate |
| 2 | Bottom Plate |
| 2 | OLED Cover |
| 4 | M2 Spacer for OLED Covers |
| 10 | M2 Spacer for Switch/Bottom Plates |
| 28 | M2 Screw |
| 10 | 3M Rubber Bumper |
Please note that options will add additional items to the cart. Removing component items from the cart will delay order processing.
NOTE: Low profile switches will fit on the 3mm acrylic switch plates, however the fit is not perfect. 3mm switch plates will be taller than the choc switches. The taller switch plate prevents the choc switches from sitting directly on the PCB. This means the switch pins do not protrude as far into the PCB. This also means that the acrylic plates will sit directly on the PCB. The switches can still be soldered to the PCB and the keyboard will function just fine.
Hotswap PCBs are held in place by the sockets. The switch plate is taller so there is less pin to go into the socket. While everything works initially, there is no guarantee it will always work. Please use this configuration at your own risk. It has not been tested for long term reliability.